TW311
Tengyu
bucket
clear
| Quantity: | |
|---|---|
Acrylic waterproof coating is based on acrylic elastic emulsion for waterproof, produced with a certain amount of modifiers, active agents, additives and fillers through scientific processing. It is environmental protection products, waterborne tasteless, convenient construction, wide range of application, and it has obvious advantages for complex site construction.
Environmental friendly coating.
Excellent weather, acid and alkali resistance.
Good performance in flexible, cold-resistant, heat-resistant
Easy to apply.
Flexible market suitability. Various colors are available as per customers demand.
Metal Roof
Flat Roof
Bathroom
Wall
1. Surface Preparation: The surface to be waterproofed must be cleaned thoroughly to remove dirt, dust grease, and other contaminants. Any cracks or defects should be repaired, and the suface should be allowed to dry.
2. Application: Use brush,roller or spray equipment, according to construction needs. One layer is about 0.5mm. In general, apply 2-3 layers. 1 squaremeter needs 2.3kg.
3. Curing: After the first layer has cured, the next layer can be applied. After the initial application and curing, the coating should be inspected for any imperfection.
Acrylic waterproof coating is based on acrylic elastic emulsion for waterproof, produced with a certain amount of modifiers, active agents, additives and fillers through scientific processing. It is environmental protection products, waterborne tasteless, convenient construction, wide range of application, and it has obvious advantages for complex site construction.
Environmental friendly coating.
Excellent weather, acid and alkali resistance.
Good performance in flexible, cold-resistant, heat-resistant
Easy to apply.
Flexible market suitability. Various colors are available as per customers demand.
Metal Roof
Flat Roof
Bathroom
Wall
1. Surface Preparation: The surface to be waterproofed must be cleaned thoroughly to remove dirt, dust grease, and other contaminants. Any cracks or defects should be repaired, and the suface should be allowed to dry.
2. Application: Use brush,roller or spray equipment, according to construction needs. One layer is about 0.5mm. In general, apply 2-3 layers. 1 squaremeter needs 2.3kg.
3. Curing: After the first layer has cured, the next layer can be applied. After the initial application and curing, the coating should be inspected for any imperfection.
