Author: Site Editor Publish Time: 2023-12-07 Origin: Site
Usage instructions
Drilling: Drilling according to the technical parameters.
Cleaning the hole: first blow the floating ash inside the hole with the air cylinder, and then brush the dust attached to the hole wall repeatedly until the hole is cleaned; Install the static mixer in the plastic bottle manufacturer, use the glue gun to squeeze out the front part of the unmixed glue, and then inject the glue in the hole, should ensure the injection sequence from the bottom of the hole to the hole, try not to mix bubbles, the glue should be filled with more than 2/3 of the hole depth.
Screw into the bar or screw: Screw the bar or screw into the hole to ensure uniform adhesive. At normal temperature (25℃), the maintenance time is 24 hours, during which the rod body shall not be touched, and it can be carried after maintenance.
Note:
The adhesive used for planting reinforcement must be modified epoxy or modified vinyl ester.
The initial extruded glue should be discarded before construction until the color of the glue is uniform and then used; When the rebar is inserted, it needs to be slowly rotated.
Clean the hole thoroughly before installation to ensure that the hole is clean and full
Make sure you do not touch the anchor solids until the gel has cured.
During winter construction, the hose can be preheated in warm water or a conservatory of about 40℃-60℃ to facilitate the extrusion of colloid; The extrusion process of the whole glue should be as uniform and continuous as possible, and avoid intermediate pauses.
In case of contact with skin, please wipe with acetone and wash with water.
When using, the special mixing tube provided with the product must be installed, and make sure that the inner helix is not missing.
